Phone Systems | Business Phones

Promotion On Hold Device

$150.00

Add to Cart:

Digital announcer/recorder
Built in 2 watt amplifier to connect directly to speakers
Designed to providemusic and promotion on hold by using playback in a continuous loop or alternating between promotions and an auxiliary music source at 2 second to 30 minute intervals
Any number of multiple messages may be recorded
Announcer comes with four professionally pre-recorded promotions on hold pacifier messages, as well as, power supply and cabling for an easy plug and play installation
Output may be connected directly to loudspeakers with messages repeated in timed intervals or played at the push of a button for museum displays, information booths, point of interest locations, etc.
7.5 minutes of user recordable memory (select fromuser recorded messages or four pre-recorded on-hold pacifier messages)
Three playback options:on demand, continuous, and timed intervals
Non-volatile memory (no batteries required)
Record from electret mic, carbon handset, tape, CD, PC sound card or any line level device
600 ohm audio output for high wattage amplifiers
Multiple message capabilities (total number of messages only limited to maximum record time)
AGC (Automatic Gain Control) for trouble free recording
Auxiliary audio (MOH) input for between message background music
Remote trigger input for on-demand playback from a remote contact closure
Press and hold play mode
Status LED forrecord and playback indication
Master and auxiliary input volume controls
I.O. communications port (allows only one DVA-2WA to announce at a time)
Power: 120V AC/12V DC, 500mA adapter provided
Dimensions: 133mm x 89mm x 44mm (5.25" x 3.5" x 1.75")
Shipping weight: 1.0 kg (2.2 lbs)
Environmental: 0*C to 32*C (32*F to 90*F) with 5% to 95% non-condensing humidity
Frequency response: 100-3.4KHz
Sampling rate: 64K (equivalent)
User message length: 7.5 minutes maximum
Recording audio input level: 30mV - 1.0V RMS (AGC range), 600 Ohm audio output level: 0.3V RMS maximum (across a 600 ohm load)
Speaker output power: 2 watt peak
Connections: (1) 6-position cage clamp terminal block, (3) 3mm (1/8") audio jacks, (1) handset jack
Pre-recorded pacifier message length: 30 seconds total
Minimum speaker impedance: 2.66 Ohms: (3) 8-Ohm speakers


Add to Cart:


This product was added to our catalog on Tuesday 18 February, 2014.


Your IP Address is: 54.226.253.34
Copyright © 2018 E System Sales, Inc. Phones and Electronic Systems 800 619 9566. Powered by Zen Cart